Community Home

Latest Discussions

  • Being used as weld wire, I intend to just leave 20% cold work and no further Anneal or Aging at my side. Suppling .062" Dia x ...

  • This new article in the journal Historical Metallurgy may be of interest to members of the ASM Archaeometallurgy Community. ...

  • The April 2023 issue of the ASM-IMS journal Metallography, Microstructure, and Analysis is devoted to archaeometallurgy. The ...

    1 person recommends this.
  • RSTC Members, Attached are our last May 17 meeting minutes. Our next meeting invitations will be sent to those who have signed ...

  • 15-5 PH and 17-4 PH are nearly identical. "Annealed" 15-5/17-4 material is untempered martensite. Consider using H1150M. -- ...

  • Dear Thermal Spray Community! Great news! The registration for ASM International Thermal Spray Society (TSS) event ...

  • Most specifications are written through a consensus process, and the balance of interests (manufacturers/producers vs. users) ...

  • The Heat Treating Society has awarded members recognized for Best Paper in Heat Treating, G. Bodeen Heat Treating Achievement, ...

  • Hi Aravind, Your question on "how industries see hiring international talents" is outstanding and very pertinent. I wish you ...

  • My specialty (failure analysis) is rare enough that I have to go where the job is. I cannot stay wedded to an individual area ...




Upcoming Events





Upcoming Chapter Events


Featured Upcoming Event




Most Active Users List