Community Home

Latest Discussion Posts

  • Hello everyone, ASM is once again hosting the Nitinol for Medical Devices course. The next course is happening on March 27-29, 2023 with a virtual option. The in-person location is the ASM Word Headquarters in Novelty, OH. Dr. Alan R. Pelton, Chief Technical ...

  • John, If the screw is cold worked then you start with wire, that is upset and broached and then the threads are rolled. The whole part is cold worked not just the threads. Regards, Michael B. Connelly, FASM, CQE

  • I would contact Insight Analytical (www.ial-fa.com) in Colorado. I used to work with them and they have a high success rate. ------------------------------ Gary Shade Manager Product Analysis (ESG) Samtec Monument co (719) 465-6579 ---------------- ...

  • Yes, there are spec tolerances, and there are analysis tolerances, and depending on the product form there may be local variations within the part. I hope that we will hear back from the original poster about what the product form was, and why ...

  • ASM welcomes Carsten Kunde! @Carsten Kunde has worked at DIAMANT Polymer GmbH since 2004 and is responsible for the "sealing agent for thermally sprayed coatings (dichtol)" department. Connect with Carsten on ASM CONNECT today! ​ ------------------------------ ...

  • Zeiss webinar December 13 at 11:00 AM ET REGISTER HERE Title: Unlocking Crystallographic & Microstructural Secrets of Your Materials Diffraction Contrast Tomography: Out of the Synchrotron and Into the Lab Speaker: Andy Holwell, Manager, ...

Upcoming Events


Upcoming Chapter Events



Most Active Members